Search results

How often do you change it when you leave it in all the time?

Here's a pic if that will help.

I just found the same thing in my tank last night after lights out. It was stretching just like the first pic in this post. From the head to where i couldn't see it anymore it was over 2 inches. How big these things get? My tank has been up and running little over 3 weeks. Setup with 100lbs LR...

Ty for the info. My LFS is recommending like 48 snails and about the same for hermit crabs for my tank and 2 or 3 shrimp. Whatcha think? I have what I'd say is a moderate amount of brown algae and the begining of hair algae. Soon as I figure out what program to shrink my photos i'll post a few.

Ty for the website

Finally after 1 1/2 years I have my 100 gallon tank up and running. It has been running for 3 weeks now. I plan on waiting for another couple weeks then i want to add cleanup crew. I'm kinda past the brown algae and getting started on the hair algae stage :) . My question for you all is what and...

Re: Scavenger Hunt Game. How about a picture of the USS INDIANAPOLIS

I have the Super Squirt model. If what you say is true, seems like I would be wasting what the pump can do. Any suggestions on what pump and GPH? Right now I plan to start with softies but I want to keep SPS down the road I hope.

WOW!!! I have a migrane now to :bugout:

Would putting some type of filter media in sump intake area or right before return cause a big drop in pods that are allowed to enter main tank? I know any filter will cut some. I guess I'm really asking what type of filter material would be the best to allow the most pods thru. I have a drawer...

Currently I have a Squence Reeflo Snapper 2500GPH ext pump. It has a 2" intake and a 1 1/2" ouput. I have an Ocean Motions Super Squirt for the closed loop I want to set in my 100g flat back hex tank. Here's my questions. With only having a ball valve between the above mentioned pump and some...

Here's a silly newb question for ya. What would be the best way to mount the pendants? With the MH pendants length going perpendicular or parallel to the tank? to give the best possible spread. _ or I

5' long tank that has a max width of 18" that cuts back from hex. So you think 7" clearance with couple of fans would ok?

I have an oak canopy with 12" clearance inside it. I have 2 reef optix III MH pendants. If I mount them inside it only gives me like 7" clearance from bottom of glass to top of acrylic tank. That would be to close and cause heat problems right? MH are 250watt DE 14k Pheonix. I was thinking about...

Just got my new Trigger sump in the other day. I have a 1 1/2" bulkhead in the return area of the sump. I bought a 90 degree elbow to put into this bulkhead to draw from the lowest point in the the sump. The problem is the elbow bottoms out on bottom of sump before it will fit in the bulkhead. I...

Yes this is for water top off in tank. It has been suggested to me to go with the Doser mixing RO/DI with Kalk for my top off. I'm justing wanting input if this is good or bad Vs. using pump and float to replace evaporated water with RO/DI water and adding a Calc Reactor. Wanting opinions to...

As subject states I'm wanting advice Pro's and Con's. This would be for Kalk water auto top off replacement. Ty :thumbup:

I just ran a dedicated 20 amp for circuit for my tank. I was afraid with all the lighting I want and equipment I need it would be to much on the circuit in that room. Don't quote me on this but I think most recommend not going over 80% of total load on a circuit. So when adding up all your...