Brookesy
Member
I installed the 2 strips one at the front and one at the back. I installed the first one on the clear Perspex cover by drilling 2 small holes and then using the brackets provided. The back lights were done similar again all though this time I used self tapping screws through 2 small pilot holes. It's not difficult although it does mean doing a bit of drilling. I'm really pleased with the results though.
It also means I can slowly increase and decrease the lighting rather than the lights being either on or off.
Sent from my iPad using Tapatalk
It also means I can slowly increase and decrease the lighting rather than the lights being either on or off.
Sent from my iPad using Tapatalk
Last edited: