crass
Member
Hi Guys .....
Im sure this has been covered 1000 times before.....but my searches dont turn up my particilar problem.
My current values are as such. (Salifert test kits)
Ca- over 500ppm
KH- 6.1
MG-1200ppm
PH-7.1
(iodine undetectable)
I use kalkwasser in my RO/DI water at half the recommended dose (as Ive just started with it) so I use 10g to 10ltrs water. I stopped using this yesturday as the calcium levels are too high)
My question is should I start dosing up my Magnesium to bring all my values into line?
KH/ph Buffer? or higher dose of kalkwasser?
Or do I just perform a few 50% water changes with my D-D H2ocean salt?
Advice is greatly appreciated?
Many Thanks
Dean
Im sure this has been covered 1000 times before.....but my searches dont turn up my particilar problem.
My current values are as such. (Salifert test kits)
Ca- over 500ppm
KH- 6.1
MG-1200ppm
PH-7.1
(iodine undetectable)
I use kalkwasser in my RO/DI water at half the recommended dose (as Ive just started with it) so I use 10g to 10ltrs water. I stopped using this yesturday as the calcium levels are too high)
My question is should I start dosing up my Magnesium to bring all my values into line?
KH/ph Buffer? or higher dose of kalkwasser?
Or do I just perform a few 50% water changes with my D-D H2ocean salt?
Advice is greatly appreciated?
Many Thanks
Dean