130 water level

[thutch6911]

Is the water level on the back of the tank supposed to be the same level on both sides?

On my tank the water level is much higher on the intake side rather then the heater / skimmer side...

 

[thutch6911]

although with I turn off one of the maxijets in seems to level out.... Is this normal?

 

[soily]

Not exactly sure what you mean here mate, are you saying the levels are different in the back chamber ie: left to right or are you saying the level in the display section is higher than in the rear chamber.

If its the latter then mine is like that as i run my weir gate about halfway up to make sure it skims the surface correctly, i also have my gate at a slight angle as this allows it to be lower so increasing flow whilst still skimming the surface. By the way i run maxijet 900's so our setups must be similar.

 

[BigAl07]

The "Intake Side" will always be FULL because it's the INTAKE side. Water level fluctuations take place opposite of that section in the Return section. That's why you see a water level indication window in the "Return Pump" section.