So I've been using Red Sea A, B, and C in liquid form, but now have some dosing pumps set up. I bought the powder of A and B and mixed both solutions as per the directions, and a little help from the forum about heating the water for B. That being said, B mixed perfectly, but after mixing A and putting it in the dosing container for a few hours I noticed there was quite a bit of sediment in the bottom. Is this normal for A or did I not mix it properly? I can't find anything on techniques for A specifically, only B. Any advice? I used 1.8L for the entire 2.2lb jug.
Red Sea Foundation A
- Thread starter Friday24
- Start date