Search results

Welcome to my @#$%!

Sounds like some sort of precipitation to me too...I had that happen to a batch of new salt water I made for water changes...lucky for me it was in a mixing barrel not my tank...every time I stired things up the water turned almost white...sounds like your water is out of balance...I would go...

I mean the flow is so low that crap grows in the small gaps obstructing flow...I do have valves but cutting back doesn't seem logical...with a total water volume in the system of 300+ gallons the 200-300 gph I'm getting from my current pump seems way low.

When I say the flow is too low I mean less than 500gph...low enough that my overflows are clogging from the lack of flow. I like the powerheads beacuse they are hooked up to a wave maker ans alternate flow...there is also a closed loop set up that cuts on and off randomly but it is not strong...

A water change always helps...Good luck....once he/she gets settled it should be very hardy...mine was the lone survivor from a all fish wipe out...

This tanks was moved a year ago...I think most of my problems have to do with water flow...I've been changing my return pump....from over powered to under powered...adding powerheads to make up for it...Getting ready to change again...I'm terrified that it will cause more problems but I need...

Ca got as low as 360...

Check this one out...drmaccorals.com. I've also had good luck with Drs Foster & Smith.

Yes I do drip Kalk on days when my ph will drop below 8 (lights off)...ph does swing from 7.98 to 8.08. I mostly rely on the Calcium reactor. KH was a little high but have brought it down to around 4. I did a large water change (around 30%) and am testing the water regularly. Only thing not...

Well...I thought the hemmorging was over...two more sps lost...one was established and no where near a powerhead...was growing fine...this is getting expensive and frustrating!!!!!

I have used the "pastey kalk" tech when they pop up in my tank from time to time and I think it works great!

I got a little over two years use out of a pin point probe...you just have to calibrate them more often with age.

I think I have/had two problems going on...the two new corals were placed high in the tank...I assumed they were in bright light at the retailer (online)bad move I guess. The three others I lost were do to flow I think...I changed my return pump to a smaller one and added some wave makers to...

You may be on to something with the direct current...effected corals were placed about 1-1.5' from a Tunze Turbelle Stream 6060. These pumps are supposed to give higher flow with low velocity but they are still pretty strong.

I guess I'm using the "shotgun" approach...dip in case of infection...and I will move the frags down to the subsrtate to try an save them. Next new purchase will start at the bottom!

Cool...thanks for the tips...I plan on doing a big water change and make frags of what is left...I'm I hearing correct that they might be getting too much light and the frags should be put low in the tank...the corals that are peeling are about 10'' and 14" below the surface. Two of the corals...

I have three acoporas, and a monti losing flesh...the acoporas are new but the monti is/was established. Any ideas? 175g Bowfront, 3 400w 10k MH, 2 96w Actinic CF, 200 gallon sump/refugium, ETS Skimmer, Geo Calc reactor, a Carbon Canister, Chiller, and return pump turning things over 3-4...

I just replaced a Dolphin pump (to big loud and hot) with a Sequence...VERY happy with the Sequence!

Are there Brittle Stars that eat coral? It NEVER leaves it.

It is some sort of banded star...seems to like that one coral...I'll keep an eye on it.