mojoreef
Just a reefer
Thought I would start a separate thread for my DIY led build. So this is going to go over a 8 foot by 3 foot tank that is 30 inches deep.. So the concept was to have multiple heat sinks mounted to a rail system and then each heat sink attached to the rail by ball joints so I can dial them in.
The first row directly over the rock work will be 6 heat sinks each of them 12 inches long by 8.46 wide and then the second row will be pull out towards the front of the tank and then angled back towards the rock work. The concept their would be to light the coral that would be under top corals and then also to blend the lights from both type of heat sinks.
So the color layout for each type of heat sink will be as follows
So the totals will be 216 Cree LED emitters, 9 meanwell drivers, 9 fans 18 resistors and fuses, 216 Carlco wides optics and 9 heatsinks. Should be cool!
mojo
So the totals will be 216 Cree LED emitters, 9 meanwell drivers, 9 fans 18 resistors and fuses, 216 Carlco wides optics and 9 heatsinks. Should be cool!
mojo
The first row directly over the rock work will be 6 heat sinks each of them 12 inches long by 8.46 wide and then the second row will be pull out towards the front of the tank and then angled back towards the rock work. The concept their would be to light the coral that would be under top corals and then also to blend the lights from both type of heat sinks.
So the color layout for each type of heat sink will be as follows
So the totals will be 216 Cree LED emitters, 9 meanwell drivers, 9 fans 18 resistors and fuses, 216 Carlco wides optics and 9 heatsinks. Should be cool!
mojo
So the totals will be 216 Cree LED emitters, 9 meanwell drivers, 9 fans 18 resistors and fuses, 216 Carlco wides optics and 9 heatsinks. Should be cool!
mojo