[saltwaterfarm]

Thanks so much everyone!

Originally Posted by sasquatch

just another excuse to hang out at the plumbing section huh

I have spent WAY to much time there recently!!!!

OK, now for the dilemma...
Return bulkhead seeping.
Nothing good at Lowes. I did pick up a sink pop-up drain gasket while I was there on the off chance that the lip on it would comfortably sit inside the hole. It didn't. So, of course I am burning my brain trying to figure out a solution. Then I remember Doni's old sump sitting on my back porch. Luckily it also had a bulkhead on one side. Of course, the seal is not the same. It's a little smaller (O.D.) and a little bit thicker. Then, I get this idea that I could put the original seal inside and the other (thicker) one on the outside. That's what I did. No leak. My question is....
WILL THIS CAUSE STRESS ON THE GLASS???

Thanks Again! I need all the help I can get!!!