| Nikki, I was talking to Mojo on the phone about this and he suggested using thin fishing line run down the joint. Then clamp lightly, apply cement, slowly pull out the fishing line and apply a little more clamping pressure. Also if you have access to a router with a flush trim bit w/ a bearing guide then you can leave the edges a little long and trim them off after the cement sets up. Good luck and let us know how it goes.
__________________
John
Tank: 29g glass Pumps: Mag5.0 return - (3) rio 100 PHs Lighting: (1) 150w XM 10K/(2) 30W actinics
Equipment: Aqua C Urchin skimmer- CPR Fuge, Titanium Heater -Red Sea wavemaster Pro
Tank: 210g 1/2" Acrylic, dual overflows, 75g glass sump w/ 20g fuge. Pumps: Mag24 return - (2) MAG24s running 2 closed loop systems. Lighting: (3) 400w XM 10K/(2) Custom Sealife 96w PC - 25w dimmable incandescent Moonlight
Equipment: Aqua C EV180 skimmer - CR500 calc reactor - Titanium Heater -
AquaLogic single Stage Temp Controller - Aquanetics 1/5Hp Chiller - Neptune sys aquacontroller
|