rsm

  1. J

    Anybody using 2 kessil 360we on a RSM 250?

    2 kessil 360we with kessil conmtroller. Red Sea Max 250 with live rock about half way up from the sand bed. mixed coral, most softies, on rock and on sand . Question is, if I am using kessil goosenecks, how far apart from center of the tank should they be placed for best spread, and how far...
  2. D

    RSM130D - Skimmer options

    Hello all I am currently running a Tunze 9001 skimmer in the back of my RSM130D, but am really after a skimmer that surface skims. I know a lot of people run the media rack and tunze 9001/9002. but have taken out the media rack and am using a canister filter for running my mechanical filtration...
  3. J

    rsm 130 rear sump question

    The rear sump of my RSM 130 is level with water across all chambers with no movement. My question is, behind the gate (1st chamber) shouldn't the water have a "Waterfall" effect dropping water down into the chamber from the display section of the tank? I have a Media rack set up behind the gate...
  4. curly01

    Lifereef system

    I have a lifereef system that I am wanting to sell as I don't have my tank anymore. It's for a RSM 250. Can send you pics, It just needs good cleaning. Asking 700 am willing to ship.
  5. J

    Tunze 9001 Skimmer RSM 130 installation

    Original RSM 130. Stock skimmer not doin anything! Bubbles are being made and are just not reaching into the cup. Valve all the way open and still no dice. Heard the way to go on replacement was with a Tunze 9001. Has anyone installed this without a media rack? Or is a media rack required...
  6. J

    Where to attatch kessil gooseneck?

    Took the top off and have attached a Kessil gooseneck on the back of my RSM 130 next to the skimmer. I have it clamped to the plastic (not the tank) which is very thin and when I walk by the tank the kessil starts bouncing slightly. Is this a sturdy enough location? I know attaching it to the...
  7. J

    Skimmer not making its way into the cup RSM 130

    Purchased a used, up and running RSM 130. Have had it up and running at my house now for 2 weeks and Skimmer is bubbling trying to make its way up but just cant seem to get out of the neck into the cup. (I have read that you can adjust the neck but the neck is built into the skimmer cup and...
  8. S

    RSM 250 and 500 for sale

    Hi all, I am unfortunately selling my RSM 250 It has been a wonderful tank and have had no issues out of it. I did remove the top light and went with 2 AI leds. They give out plenty of power for soft/hard corals and all pumps are new. I also have a new skimmer in box. Always keep a spare:) It...
  9. S

    Never used Red Sea Max 500 for sale

    New RSM 500 for sale, all pumps, Trigger system ruby sump 4426. Custom made stand piping and all connectors ready for set up. Moving and can not bring with us. Never been set up. Never had water in it. Pick up only! $2500
  10. C

    Cantwell's RSM 650 Thread

    The adventure begins! My RSM 650 delivered on Friday (10/7/16), and it was a great weekend putting it together. This system is amazing. Time to start brewing some water, and then I'll be calling Richard at Tampa Bay Saltwater to place my rock and sand order. Special thanks to Vivid...
  11. C

    Cantwell's RSM 650

    Stay tuned. The order has been placed. I have been a spectator for a while now, but the new house and pocketbook are finally ready to begin this adventure.
  12. J

    Wanted to Buy RSM 250 Skimmer Flap

    Hey everyone I am looking for a skimmer flap for a Red Sea Max 250 hood. If you've gone rimless, or done other mods and you are not using the original hood and have this flap available I am interested in buying it for you. Thanks! Jack
  13. modulok

    Size of flow pump plumbing

    I was looking to add some Loc Line plumbing to my RSM S series. I tried 1/2" female elbow barb adapter and 3/4". The 1/2" barb seemed a bit loose for the green tubing, and 3/4" was too big. Is this possible to do...
  14. modulok

    RSM S500 Items - Lights & Skimmer

    I recently upgrade my lights and skimmer and no longer need the original Red Sea Max S 500 T5 light fixture and C-Skimm 1800. Both have been in a smoke free home. I will provide photos later, but the lights are in great shape and worked great for the last 4 years. However the bulbs are almost a...
  15. CoachLarry

    Brand new to the saltwater hobby

    Hello all. My name is Larry and I live near Annapolis Maryland. I am brand new to the saltwater hobby. I recently converted a 20 hex fresh to saltwater which I plan to use long term as my quarantine tank, and then just purchased a new RSM E-260 over the weekend. I set the new E260 up this...
  16. D

    dustinc's SPS E-260

    New home, new build... I have been in the hobby for about 12 years and had several different aquariums throughout the years including complete custom systems and various "package" systems. I've owned the original RSM 250 & a RSM S-650 and I was always impressed with the build quality, but not...
  17. ScoubaSteve

    Hello RSM Community-New to Forums

    Hello RSM Community, First let me introduce myself...My name, if you have already guessed, is Steve. I live in beautiful Middle Tennessee and have been in the hobby on and off for 5 years. My enthusiasm for this wonderful hobby started in late 2010 after a deployment to Iraq. After...
  18. F

    If you were to start again..

    So, if you had an RSM all in one tank, specially the 250 MAX or C.... What would you do from the outset? Modification/equipment wise? Add a sump?
Top