You can also "cure" your rock and get rid of the pests (and all the good stuff) and not lose the rock.
aptiasia is easy easy to get rid of with aptaisia-x (and other solutions). I have had bryopsis in a tank I started dry and QTed pretty extensively. You will get pests. How much effort you...
I added a few corals a couple of weeks back. The arcos died -I assume from the dip :(
I'll add more this week.
I just got back from vacation and there is another bacterial bloom. Nothing major, just some cloudy water. It seems to be cycling just like Eric Bornmans article indicated.
Now...
The cycle is done and i have two snails in there. The diatoms were thick and heavy and are now receding. It was interesting on the orp of the apex, I could see when the lights were on and they were producing O2,and then after a few weeks as they died off there stopped being a daily increase in...
I have to say this one is a lot of work to set up. The leaks really took a long time to get through. Lots of equipment, and my husband built a really cool light fixture. I'll try to get some photos tonight. Luckily hes into the carpentry part, no so much the fish part, but he does like...
Let's take a tour of the sump!
BRS dual reactor for carbon and GFO. Currently only running carbon
Vetra M1 return pump
Tunze ATO
manifold with drops for both reactors, and one extra for future expansion
Reef Octopus 200int skimmer
BRS single reactor for bio pellets.
Apex salinity, ph, temp...
Full of water for about a month and cycling. Red sea promptly sent a part, and it all leaked again. Afeter much pulling of hair I realized the part I was screwing in was bad. mis-molded. I fit a new part and it went right in. Since the part I had was all glued in, I took a razor blade and...
yes - I install the float where the circulation pump is. If you still have two pumps you might be able to contact Red Sea and get the upgraded pump (they gave me mine for free when one of mine went out)
I have the tunze nano on my 130d. It works fine. I put the float in the same chamber as the return pump so that stays consistent and I don't get bubbles. I have the return water line in the heater section, but I think anywhere in the back should be fine. I put a 5 gallon bucket under the...
Thanks Dave,
the threaded fitting has some extra plastic flash on the threads that I think caused the issue. I cut those off, used thread sealant, and everything is good!
Hi,
We are setting up a reefer 525. I have a threaded fitting to the red sea fitting. I don't want to use the barb fitting. I got this one from pvcfittingsonline that many people have used
3/4" Schedule 80 PVC (MPT x S) Male 836-007
The fitting keeps leaking. Wrapped with tape, leaks...